![]() If the route change button is grayed out, then there is no new route change information. This is the starting time for the change. Double-clicking on any time will show the route as of that time. Anytime any hop in the route changes, PingPlotter stores the old and new route data and adds the time of the change to this list box. ![]() 3.5 seconds).Ĥ - The Route Change button is used to show the history of route changes. If the up/down arrow doesn’t have the amount of time you want, just type the time interval you want (e.g. If you’re doing a quick test, you might want to set this to something lower (1 - 5 seconds). If you’re doing a long term monitoring project, you may want to set it to be longer (15 - 60 seconds). The name will show as "resolving" until the request is complete.ģ - The Trace Interval is the amount of time PingPlotter will wait between each sample set. ![]() If you enter an IP Address here (and press the start" button, or the enter key on your keyboard) PingPlotter will start tracing immediately before the IP is resolved to a name. If you haven't entered anything in this field, clicking on it will bring up a "history pane" that shows targets you've recently traced to. If you're using PingPlotter Pro, you can also start tracing to a new target, or create a new summary screen from hereĢ - The Target Name field is where you enter the IP Address or DNS name of the destination you want to trace. 1 - The Start/Pause button - clicking the drop-down menu on this button will provide options to reset and restart your trace, limit your trace count, or trace continuously.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |